View Single Post
Old 08/12/2017, 07:18 PM   #19
djbon
Registered Member
 
djbon's Avatar
 
Join Date: Jan 2015
Location: Kota Kinabalu, Sabah, MY
Posts: 813
You must use a proper wattage soldering gun to do the job. It's not easy if you never did any. Steady hands, proper heat and proper soldering lead is required. Un-solder requires steady hands, proper heat and unsoldering tools (i use small flat head screw driver to lift up the "leg" from solder pad), i would pre-solder a small amount of fresh lead. The heatsink cools down your solder very fast, so I would say unsoldering job is more difficult to do for inexperience DIYer.


__________________
75 gallon DT, 5 gallon sump, DIY LED bar with moonlight, DIY Arduino controller

Current Tank Info: 75 gallon/Arduino Controller
djbon is offline   Reply With Quote